If the device shows this recording error: The device was unable to record the video. The request (Get Media List) failed to send. This request can only be sent over a network (either Wi-Fi or USB), but the GoPro is not connected via the network, there are a few most likely causes:
The GoPro has been disconnected. Close Snappic, reopen, and reconnect devices. Ensure that the GoPro connection is WIRED for optimal performance.
The GoPro is connected to another device other than the one running your video editing software. Ensure there are no other devices connected to the GoPro (Check GoPro Quik App, Bluetooth, Wi-Fi, and USB). Reset wireless connections if needed:
Swipe down on the touch display (Hero 11/10/9 Black, swipe left after swiping down)
Tap [Preferences]
Tap [Wireless Connections]
Scroll down and tap [Reset Connections]
Tap [Reset]
To reconnect the GoPro to a device running video editing software:
Swipe down on the touch display (Hero 11/10/9 Black, swipe left after swiping down)
Tap [Preferences]
Tap [Wireless Connections]
Set [Wireless Connections] to ON
Tap [Connect Device]
Tap [GoPro Quik App]
Install/Open the GoPro Quik App on the video editing device
Navigate to the [GoPro] Tab
Tap [Connect a GoPro]
Tap [Connect Camera]
Make sure that the cable you are using to connect to the GoPro is a data transfer cable and not a charge-only cable.